smartos installs fine but won't boot

Discussion in 'Other Virtual machines' started by KfirO, Jun 23, 2016.

  1. KfirO

    KfirO Bit poster

    Messages:
    3
    Hello.
    I'm using parallels desktop 11 and I'm trying to run smartOS.
    so first I downloaded latest smartOS ISO. created a new OpenSolaris virtual machine. installed the smartOS from the iso.
    after reboot, i see the screen of parallels BIOS boot page, and last line says: "Trying to boot from Primary Master IDE drive .."
    configuration:

    Hard Drive - size 64gb, location IDE 0:0
    Optimization: Enable Adaptive Hypervisor is enabled
    CPU & Memory: Processors: 8, Memory: 4096MB
    Graphics: Graphics Memory - 64MB

    any ideas how to boot SmartOS properly ?
    thanks!
     
  2. KfirO

    KfirO Bit poster

    Messages:
    3
    ok. i just need to boot again from the installation iso. it detects the installed os and runs it.
     
  3. PaulChristopher@Parallels

    PaulChristopher@Parallels Product Expert Staff Member

    Messages:
    3,158
    Great! We appreciated your effort. Feel free to reach out anytime. We are here to help! Thanks!
     

Share This Page